This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
indoor-wifi [2008/09/23 23:28] pratap |
indoor-wifi [2008/12/17 17:44] (current) viveks |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== About ===== | ===== About ===== | ||
The WiNGS indoor wireless testbed consists of about 60 nodes, deployed in the Department of Computer Sciences building. This wireless testbed is part of the [[http://www.cs.wisc.edu/wings/|WiNGS lab]]. | The WiNGS indoor wireless testbed consists of about 60 nodes, deployed in the Department of Computer Sciences building. This wireless testbed is part of the [[http://www.cs.wisc.edu/wings/|WiNGS lab]]. | ||
+ | |||
+ | ===== Status ===== | ||
+ | The current status and hardware available at each node of the testbed can be viewed at [[ http://128.105.118.9/wiki/doku.php?id=testbed_status | Testbed Status ]] | ||
===== Access ===== | ===== Access ===== | ||
Line 33: | Line 36: | ||
All the nodes can be accessed through the IP address or hostname node-. The nodes are fitted with 802.11 abg wireless cards. | All the nodes can be accessed through the IP address or hostname node-. The nodes are fitted with 802.11 abg wireless cards. | ||
+ | |||
+ | ==== Wireless cards on nodes ==== | ||
+ | There are 9 nodes with Atheros cards that are connected to the testbed. The node numbers are : 70,22,43,54,29,57,89,53,51,50 | ||
+ | |||
==== Node Mapping ==== | ==== Node Mapping ==== | ||
Line 44: | Line 51: | ||
==== How to install a new driver on a node? ==== | ==== How to install a new driver on a node? ==== | ||
- | TODO | + | To create a new driver in the image "code_client" use the following steps. |
+ | |||
+ | chroot /tftpboot/code_client/ /bin/bash | ||
+ | make KERNELPATH="/lib/modules/2.6.16.19-soekris/build/" | ||
+ | make KERNELPATH="/lib/modules/2.6.16.19-soekris/build/" install | ||
+ | |||
+ | then SSH to the node and remove the existing driver using the command "rmmod" and load the new driver module using the following command | ||
+ | |||
+ | mdoprobe ath_pci | ||
==== How to add a new node? ==== | ==== How to add a new node? ==== |